Iridium SHOUT ns General Description Manual page 53

At the bottom of the Geofences window are a set of buttons. Descriptions of the buttons
are as follows:
Configure
Delete
Clear
Create Geofence
NAL Research Corporation (451-01001.B)
Selecting the Configure button saves the list of geofences on the
SHOUT ns.
Deletes the selected geofence.
Deletes all configured geofences.
Figure 23. Create/Edit Geofence window.
Opens a window to create a geofence by adding points on a map.
The window is shown in Figure 23. Clicking anywhere on the map
will add a point to the geofence. Each point is connected to its
previous point. Clicking an existing point will delete it from the
geofence. Dragging an existing point will move that point to where
it is dragged. A geofence is complete when the start point is clicked.
The Save Points button transfers the marked points to the
coordinates list and closes the map. The Clear/Reset button is used
to clear all points on the map. The minimum number of points in a
geofence is 3 and maximum number of points is 50.
53