At Command Mode - Iridium SHOUT ns General Description Manual

STEP 5 – The Android device will provide a passkey for pairing. Using the AT^BTPASS
###### command, enter the pairing key into the SHOUT ns. After several seconds, the
SHOUT ns BT LED should change from blinking to steady illumination to indicate it has paired
successfully.
STEP 6 – Remove the SHOUT ns from Command mode by sending the ^TRK command.
Unplug the SHOUT ns from the USB cable.
Once the devices have been paired, the user can launch the NAL SHOUT Android app on
the smartphone. Once the SHOUT ns has been successfully paired with a device, the SHOUT
ns should automatically pair with the Android device in the future.

4.7 AT Command Mode

For scenarios where computer control of the SHOUT ns is desired, this can be achieved
using a computer attached to SHOUT ns USB interface through a USB cable. For example,
the SHOUT ns can be turned off using the AT command ^SHUTDOWN. If the device is sleeping
or in low-power in between reporting cycles, pressing the power button will turn the SHOUT
ns on for 10 seconds. During this time, user can take the device out of Tracking mode and
put it into Command mode by entering a sequence three pluses, "+++". If "+++" is not
entered within 10 seconds, the SHOUT ns goes back to "sleep". See Section 5.2 Modes of
Operation for a more detailed description of the Command Mode and see the NAL document
"AT Commands for Model SHOUT ns" [1] the full list of capabilities of the AT Commands.
NAL Research Corporation (451-01001.B) 22