Iridium SHOUT ns General Description Manual page 46

6.2.2.2.2.1 Geofence Check Frequency
This parameter sets the maximum time between position updates to check if the device is
in a geofence. If a valid GPS position is received before the next check, the countdown to the
next check is restarted. The AT command associated with this setting is ^GFCF.
6.2.2.2.2.2 Allowed GPS Acquisition Time
This parameter sets the amount of time the geofence check attempts to acquire a GPS
position. If the SHOUT ns fails to acquire a position in the time allowed, the geofence check
will be aborted and will occur at the next scheduled check or the next time the GPS receiver
has a valid position. The AT command associated with this setting is ^GFCF.
6.2.2.2.3 Interval Tab
The Interval tab offers four settings: Use Alternate Interval for Motion, Time Between
Reports (Standard and Motion), Time To Keep Trying (Standard and Motion), and Delayed
First Report (Standard and Motion) as shown in Figure 18.
Figure 18. Tracking Profile window with Interval tab with Standard and Motion options.
6.2.2.2.3.1 Use Alternate Interval for Motion
This setting, when set to Yes, causes the SHOUT ns to use alternate Time Between
Reports, Time To Keep Trying, and Delayed First Report settings while in motion. To set these
NAL Research Corporation (451-01001.B) 46