Table of Contents
Advertisement
6.2.2.2.1.7 Skip Reporting when Stationary
This parameter limits the SHOUT ns from sending tracking reports when it has not moved
out of a specified radius. When enabled, this causes the unit to be bounded by a sphere with
a specified radius. While the unit remains in the sphere, report sending skips a specified Cycles
to Skip number of report cycles. When the Cycles to Skip value is reached, the SHOUT ns will
report for a specified number of Send While Stationary cycles. The process is repeated until
the unit leaves the sphere. Upon leaving the bounding sphere, a new boundary will be created
at the current location of the unit and the SHOUT ns will report for the specified Send While
Stationary cycles. If On, Skip All is selected, the Cycles to Skip parameter is disregarded and
the unit only sends the Send While Stationary cycles each time a new sphere is established.
The AT command associated with this setting is ^SPSR.
6.2.2.2.1.8 Iridium Allowed
This setting lets the user enable/disable the Iridium link. Refer to the Queue Restricted
Reports option for additional details. The AT command associated with this setting is AT^LNK.
6.2.2.2.2 Geofence Tab
The Geofence tab offers two settings as shown in Figure 17: Geofence Check Frequency
and Allowed GPS Acquisition Time.
Figure 17. Tracking Profile window with Geofence Frequency tab.
NAL Research Corporation (451-01001.B)
45
Advertisement
Table of Contents
