Iridium SHOUT ns General Description Manual page 15

Each LED can be enabled and disabled through a setting in the general configuration profile
(^LEDS) (see Section 6.2.2.1 General Profile Settings). Table 1 below describes the function
of each LED.
Figure 3. Control Buttons and Status LEDs on the SHOUT ns front face.
LABEL NAME
Power Device is off
During Operation:
BATT Battery
GPS GPS GPS Off or time only
BT Bluetooth Bluetooth off
No successful report
STAT Status
transmission
IRDM Iridium Off or has no signal
NAL Research Corporation (451-01001.B)
LED OFF
Once every 5 sec: Device is on
and sleeping in Normal Mode
Once every 2.5 sec: Device is
on and sleeping in Emergency
Mode
During Operation:
Charge Required
While Charging:
2-D fix or dead reckoning
1 sec: Bluetooth on and not
connected / pairing
1 sec: Last report transmission
failed
Has 1 - 2 bars of signal
Table 1. Description of LED states.
LED BLINKING
Charge under 80%;
1.25 sec On, 0.25 sec Off
Charge under 20%;
0.125 sec On, 1.00 sec Off
Charge in Progress;
1.25 sec On, 0.25 Off
LED SOLID
Device is on and awake
During Operation:
Charge over 80%
While Charging
Charge Complete
3-D fix
Bluetooth on and
connected
Last report
transmission succeeded
Has 3 - 5 bars of signal
15