Wavetronix Click 100 Series User Manual page 201

CHAPTER 23 • CLICK 301
200
Setting
Incoming Connec-
tion
Response
Figure 23.12 – Expert Driver Connect Tab
Description
Allows you to configure how the device reacts to incoming connections
over the network.
Never rejects all external connection attempts.
Accept DTR accepts external connection requests only when the
Modem Control In input is asserted; this setting cannot be used with
Modem mode.
Accept All is the default setting and accepts any incoming connection
when a connection is not already established.
Lets you set character response. When this is set to Character, a single
character is transmitted to the serial port when there is a change in
connection state:
C = connected
D = disconnected
N = host unreachable
The IP address of the host connecting to the CoBos device will be
provided when you use verbose mode. This option is overridden when
the Active Start Modem Mode or Active Start Host List is in effect. The
default setting is Nothing.