Before You Start ]; Important Notice; Safety Warnings - Tecnotion TM3 Series Manual

1. [ BEFORE YOU START ]

Please read the following instructions very carefully.
They are important for a safe and warranted installation and operation of
the Linear Motor
1.1

Important notice

Before installing and using the Linear Motor, read this instruction
manual carefully. The manufacturer declines all responsibility
in case of accident or damage due to negligence or lack of
observance of the instructions described in this manual. The
manufacturer also declines all responsibility in case of accident
or damage in conditions that differ from those indicated
in the manual; Tecnotion also declines all responsibility
for damage caused by improper use of the Linear Motor.
Handle the components of the Linear Motor with care, packed
as well as unpacked. Especially the magnet plates are sensitive
to mechanical shocks. Never drop a magnet plate or release it in
an uncontrolled way.
Do not expose the magnets to temperatures higher than 70° C.
The magnets may be demagnetized at higher temperatures.
Unpack the Linear Motor and check its integrity. If there is any
irregularity, contact the dealer or manufacturer, signalling the
nature of the defects.
Make a note of the serial number. This facilitates the
correspondence with the supplier.
©2015 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior notice.
Safety and information symbols:
The lightbulb describes a 'Tip' .
The exclamation mark is a, non safety related, important notice
that the user should be aware of.
The warning signs inform about safety information that the user
should respect.
1.2

Safety warnings

The Linear Motor is used as a part of a machine. The user has to
take care that the machine as a whole fulfils all CE require-
ments.
The magnet plates show large attraction forces on all soft
magnetic objects such as iron. These forces cannot be controlled
by hand. They may cause serious jamming danger. Do not
bring any soft magnetic objects (iron) nearer than 25cm of the
magnetic side of the magnet plate.
Be sure that the magnetic plates are fixed into your machine
before removing the magnetic field protection plates. Put the
magnetic field protection plates on the magnetic plates again
before dismounting them.
Magnetic sensitive objects like banking cards, pacemakers or
other magnetic information carriers may be damaged if they are
brought within 1m of the magnet plates.
CH 1 BEFORE YOU START
Tecnotion | www.tecnotion.com | sales@tecnotion.com
5