Tecnotion TM3 Series Manual page 6

The magnet plate and coil unit can be damaged when cleaned
with a non-prescribed cleaning agent.
Use only Isopropanol as a cleaning agent.
UV Blacklight can cause irreversible damage to the eyes
and other tissue when exposed. When using a UV Blacklight
installation wear appropriate protective clothing and glasses.
The magnet plates attract each other while mounting. This may
cause serious jamming danger. Take care that a magnetplate
does not damage the adjecent magnet plate while mounting.
If at any time and in any situation there is any doubt about
the safety of the Linear Motor, do not use it and contact your
supplier.
The Linear Motor is powered by a servo amplifier. In case of a
power disruption or fatal error this may automatically result in
a free run out of the motor. Make mechanical precautions to
prevent damage on the motor or your machine in the case of
such an event.
©2015 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior notice.
Tecnotion | www.tecnotion.com | sales@tecnotion.com
Before installing the motor, make sure that the supply mains
are grounded and operate in conformity with the regulations in
force.
Make sure that there is an effective protective earth. Make sure
that there is no voltage at the wire terminals before connecting.
An earth connection does not work on non-conducting
mounting surfaces like granite. In these cases the protective
earth must be established by an earthing wire.
Before carrying out checks or doing any maintenance, clear the
system by disconnecting the voltage. Be sure that there is no
possibility of accidental connections.
CH 1 BEFORE YOU START
6