Ricoh BR-C1a Basic Service Training page 456

Re-assembling the Fusing Unit – 2 (Hot Roller)

Always inspect and clean a hot roller for contamination by grease before
re-installing it. This is especially important for a used roller.
 Grease on the surface of the hot roller can cause the surface of the roller
 If peeled particles reach the surface of the fusing belt, this can cause

Clean the entire surface of the hot roller with a dry cloth.

Next, clean the entire surface with a cloth dampened with water (not
alcohol).

Finally, clean the entire surface again with a dry cloth.
Slide 456
No additional notes
Replacement and Adjustment
to peel.
glossy patches or streaks on prints.
456
BR-C1 Training