Ricoh BR-C1a Basic Service Training page 405

Replacement and Adjustment
After Replacing the Parts in the PTR Unit
1. Re-assemble the machine and make sure that the machine
is off.
2. Open the left and right front door of the machine.
3. Turn the machine on.
4. Enter the SP mode.
5. Do SP7622-xxx to set the counters for the replaced parts to
zero.
 The procedure in the manual has a list of SP codes for
each part.
6. Close the left and right front doors.
7. Process control executes automatically.
8. After process control executes, the operation panel will
display "Ready".
 This completes the procedure.
 Do SP3012-001 to confirm that process control executed
successfully.
Slide 405
 If process control fails, you will see "Fail" appear on the operation panel, and
then the machine will issue an SC code.
 Do the procedure recommended to resolve the problem that triggered the SC
code.
 You must then execute SP3011-002 to execute process control manually
because it will not execute again automatically.
405
BR-C1 Training