Ricoh BR-C1a Basic Service Training page 381

Replacement and Adjustment
9. Once again, open the left and right door of the machine.
10. Install the PTR unit and drum cleaning unit.
11. Close the gap between the lubricant blade and cleaning
blade.
12. Enter SP mode, reset the PM counters for all the replaced
parts (SP 7622-xxx), and leave SP mode.
13. Close the left and right front doors of the machine.
14. Process control will start automatically.
15. The machine will display "Ready" after process control
executes successfully.
16. Do SP3012-001 to confirm successful completion of the
process control.
17. Leave the SP mode.
18. This completes the procedure.
Slide 381
 If Process Control Fails, it is the same as explained earlier in the PCDU section
 If process control did not end successfully, the machine will issue an SC
code.
 Correct the problem by following the steps recommended for releasing the
SC code.
 After correcting the problem, service control will not execute automatically,
so you will need to execute process control manually with SP3011-002.
After Replacing the ITB - 2
381
BR-C1 Training