Accessing the
To access the CLI on the adapter to modify VLAN and priority settings,
perform the following procedure:
CLI Using a
Terminal
1. Connect the USB-A connector of the cable to the USB-A receptacle on
Emulator
Program
2. Connect the other end of the cable, USB Micro-B connector, to the
3. Start the terminal emulator program with the COM number that you
4. Configure the terminal emulator program as follows:
5. Press Enter on the terminal emulator program on the management PC.
6. To configure the VLAN and Priority settings, go to "Configuring the
a management PC.
USB Micro-B receptacle on the AT-2914GP/SP adapter.
noted from Device Manager.
Baud rate: 115200
Data bit: 8
Stop bit 1:
Parity: None
Flow control: None
The VLAN and Priority configuration menu is displayed as shown in
Figure 27.
.
Figure 27. VLAN and Priority Configuration Window
VLAN and Priority Settings on the Network Adapter" on page 60.
Chapter 4: Configuring the VLAN and Priority
59