Starter - Kubota V3300-E2B Workshop Manual

V3300-E2B, V3300-T-E2B, WSM

(7) Starter

Clearance between Outer Rotor and Pump Body
1. Measure the clearance between the outer rotor and the pump
body with a feeler gauge.
2. If the clearance exceeds the allowable limit, replace the oil pump
rotor assembly.
Factory spec.
Clearance between
outer rotor and pump
body
Allowable limit
Clearance between Rotor and Cover
1. Put a strip of plastigage onto the rotor face with grease.
2. Install the cover and tighten the screws with the specified torque.
3. Remove the cover carefully, and measure the amount of the
flattening with the scale and get the clearance.
4. If the clearance exceeds the allowable limit, replace oil pump
rotor assembly and the cover.
Factory spec.
Clearance between rotor
and cover
Allowable limit
Tightening torque Oil pump cover screw
Overrunning Clutch
1. Inspect the pinion for wear or damage.
2. If there is any defect, replace the overrunning clutch assembly.
3. Check that the pinion turns freely and smoothly in the
overrunning direction and does not slip in the cranking direction.
4. If the pinion slips or does not rotate in the both directions, replace
the overrunning clutch assembly.
S-73
DIESEL ENGINE
0.100 to 0.184 mm
0.0039 to 0.0072 in.
0.3 mm
0.0118 in.
W1071334
0.025 to 0.075 mm
0.0010 to 0.0030 in.
0.225 mm
0.0089 in.
7.9 to 9.3 N·m
0.80 to 0.95 kgf·m
5.8 to 6.9 ft-lbs
W1148218
W1075769
KiSC issued 06, 2006 A