Kubota V3300-E2B Workshop Manual page 115

V3300-E2B, V3300-T-E2B, WSM
Flywheel Housing
1. Remove the flywheel housing.
(When reassembling)
• Tighten the flywheel housing mounting screws with even force on
the diagonal line.
• Make sure the crank cases 1 and 2 are clean. Install them in
position, referring to the flywheel housing's contoured face.
Flywheel housing
Tightening torque
mounting screw
(1) Flywheel Housing
Crankcase 2
1. Remove the crankcase 2 (1).
(When reassembling)
IMPORTANT
• Make sure the crankcase 1 and 2 are clean.
• Apply liquid gasket (Three Bond 1217D) to the crankcase 2
as shown in the figure.
• Tighten the crankcase 2 mounting screws with even force on
the diagonal line.
• Confirm that the liquid gasket coating surface is free of
water, dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
Crankcase 2 mounting
Tightening torque
screw
(1) Crankcase 2
Crankcase 1 and Crankcase 2
(When reassembling)
• Match the crankcase 1 and 2, referring to the flywheel housing's
contoured face.
• Tighten the crankcase 2 mounting screws loosely.
• Tighten up the jig to the specified torque same as the flywheel
housing screw. This helps to minimize the level difference
between the crankcase 1 and the crankcase 2 (at the flywheel
side). Possible gap must be 0.05 mm (0.0020 in.) or smaller.
Crankcase 2 mounting
screw
Tightening torque
Flywheel housing
mounting screw
(1) Crankcase 1
(2) Gap to be smaller than 0.05 mm
(0.0020 in.)
(3) Flywheel Housing
S-52
DIESEL ENGINE
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
W1060705
49.0 to 55.9 N·m
5.0 to 5.7 kgf·m
36.2 to 41.2 ft-lbs
(2) Liquid Gasket
W1060825
49.0 to 55.9 N·m
5.0 to 5.7 kgf·m
36.2 to 41.2 ft-lbs
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
(4) Crankcase 2
(5) Jig
W1111351
KiSC issued 06, 2006 A