Servicing; Cylinder Head - Kubota V3300-E2B Workshop Manual

V3300-E2B, V3300-T-E2B, WSM

[3] SERVICING

(1) Cylinder Head

Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage, and
remove the bearing (2) with a puller (3).
(1) Rotor
(2) Bearing
Top Clearance
1. Remove the cylinder head (remove the cylinder head gasket
completely).
2. Bring the piston to its top dead center fasten 1.5 mm dia. 5 to 7
mm long fuse wires to 3 to 4 spots on the piston top with grease
so as to avoid the intake and exhaust valves and the combustion
chamber ports.
3. Bring the piston to its middle position, install the cylinder head,
and tighten the cylinder head screws to specification. (Head
gasket must be changed to new one).
4. Turn the crankshaft until the piston exceeds its top dead center.
5. Remove the cylinder head, and measure squeezed fuse wires for
thickness.
6. If the measurement is not within the specified value, check the oil
clearance of the crankpin journal and the piston pin.
Factory
Top clearance
spec.
Cylinder head mounting
Tightening torque
screw
(1) Fuse
S-56
DIESEL ENGINE
(3) Puller
W1019701
V3300- 0.72 to 0.90 mm
E2B 0.0283 to 0.0354 in.
V3300- 0.92 to 1.10 mm
T-E2B 0.0362 to 0.0433 in.
98.1 to 107.9 N·m
10.0 to 11.0 kgf·m
72.3 to 79.6 ft-lbs
W1049122
KiSC issued 06, 2006 A