Using Recovery Wizard To Restore Computer - Winmate IP32S User Manual

3.3 Using Recovery Wizard to Restore Computer

Note: Before starting the recovery process, make sure to backup all user data. The
data will be lost after the recovery process.
Important: Before starting the recovery process, remove any expansion card.
To enable quick one-key recovery procedure:
1. Connect the computer to the power source. Make sure the computer stays plugged in to power
source during the recovery process.
2. Turn on the computer, and when the boot screen shows up, press F6 to initiate the Recovery
Wizard.
3. The following screen shows the Recovery Wizard. Click Recovery button to continue.
4. A warning message about data loss will show up. Make sure the data is backed up before
recovery, and click Yes to continue.
5. Wait the recovery process to complete. During the recovery process, a command prompt will show
up to indicate the percent of recovery process complete. The system will restart automatically after
recovery completed.
Chapter 3: Insyde H20 BIOS Setup 55