Complete Installation; Air Conditioner Use; Starting Your Air Conditioner - Digital Control - Whirlpool 1187361 Use And Care Manual

Complete Installation

1. Place window-lock bracket on top of lower window and
against upper window sash.
2. Use a in. drill bit to drill a starter hole through the hole in
the bracket into the window sash.
3. Attach window-lock bracket to window sash with #8 x
round-head screw to secure window in place.
1
2
1. Upper window sash
2. Window-lock bracket
4. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
1
1. Lower window sash
2. Foam seal
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
5. Plug into a grounded 3 prong outlet.
10
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
in.
IMPORTANT:
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
2
1. Remove clear protective film from control panel and front
2. Press POWER to turn on air conditioner.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."

AIR CONDITIONER USE

If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
Starting Your Air Conditioner -
Digital Control
panel badge.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C). When it is turned on at
all other times, it will display the previous settings.