Complete Installation; Air Conditioner Use - Whirlpool ROOM AIR CONDITIONER Use & Care Manual

1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
A
A. Top of lower window sash
B. Foam seal
2. Use a ¹⁄₈" drill bit to drill a starter hole through the hole in the
top channel.
3. Attach top channel to window sash with one ³⁄₄" screw to
secure window in place.
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.

Complete Installation

B
4. Plug into a grounded 3 prong outlet.
5. Press RESET on the power supply cord. See "Electrical

AIR CONDITIONER USE

NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Requirements."
Do not try to operate your air conditioner in the Cool mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
9