Complete Installation; Air Conditioner Use - Whirlpool AW05CR1SRHUE Use & Care Manual

Attach Side Curtains to Window
1. Pull the left-hand curtain out until it fits into the window
channel.
2. Use ¹⁄₈" drill bit to drill a starter hole through the hole in the
side curtain and window sash.
3. Insert one of the ³⁄₄" screws through the left-hand curtain and
into the window sash.
4. Repeat for the right-hand curtain.
Window Sash View
A
B
C
1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
A
A. Top of lower window sash
B. Foam seal
2. Use a ¹⁄₈" drill bit to drill a starter hole through the hole in the
top channel.
3. Attach top channel to window sash with one ³⁄₄" screw to
secure window in place.
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes
■
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
8
A. Window sash
B. Hole in side curtain
³⁄₄
C. " screw

Complete Installation

B

AIR CONDITIONER USE

5. Drill a starter hole through the notch in the side curtain and
the windowsill.
6. Insert one of the ³⁄₄" screws through curtain notch and into
the windowsill.
7. Repeat for the right-hand curtain.
Windowsill View
A
B
C
³⁄₄
A. " screw
B. Notch in side curtain
C. Windowsill
WARNING
Electrical Shock Hazard
WARNING
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4. Plug into a grounded 3 prong outlet.
5. Press RESET on the power supply cord. See "Electrical
Requirements".
Do not try to operate your air conditioner in the Cool mode
■
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.