Position The Air Conditioner - Whirlpool 1187361 Use And Care Manual

3. Pull curtain toward open end of curtain frame.
4. Insert top and then bottom of right-hand curtain frame in top
and bottom curtain guides on air conditioner.
Top view
Bottom view
8
5. Extend right-hand curtain outward so you may insert the first
screw through the middle hole of the curtain. Using a #8 x
in. pan-head screw, screw curtain to middle hole in air
conditioner cabinet.
NOTE: This screw is required to correctly attach curtain (top
to bottom) to the air conditioner cabinet.
1. #8 x
6. While the right-hand curtain is still extended, insert screws
into top and bottom slots of curtain. Using #8 x
head screws, screw curtain to the top and bottom holes in air
conditioner cabinet.
7. Slide curtain housing into guides as far as it will go.
8. Repeat above steps for left-hand curtain.

Position the Air Conditioner

Handle air conditioner with care.
Be sure your air conditioner does not fall out of the opening
during installation or removal.
The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded outlet.
Do not block the louvers on the front panel.
Do not block the louvers on the outside of the air conditioner.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
1. Put air conditioner on SMART-MOUNT
on bottom of air conditioner are behind and against back side
of windowsill. Lower window sash.
1
in. pan-head screw
in. pan-
™
tray. Check that feet