Whirlpool 1187361 Use And Care Manual page 12

To operate air conditioner with remote control
Auto Cool
Cool
Fan Only
Power Saver
Timer
NOTE: Two AA batteries (not included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To turn the air conditioner on or off:
Press POWER ON/OFF.
To select the mode:
Press AUTO COOL, COOL, FAN ONLY, or POWER SAVER.
Auto Cool - fan speed is adjusted automatically.
Fan Only - fan speed is automatically set at Turbo.
Cool or Power Saver - you can adjust the fan speed.
12
POWER
ON/OFF
Turbo
High
FAN
SPEED
Low
Temp / Time
POWER
ON/OFF
Auto Cool
Cool
Fan Only
Power Saver
To select the fan speed (in Cool or Power Saver
mode only):
Press TURBO, HIGH or LOW.
SPEED
To raise the temperature:
Press the up arrow button. Each time you press or hold the up
arrow button, the temperature will increase 1º until it reaches
86°F (30ºC).
To lower the temperature:
Press the down arrow button. Each time you press or hold the
down arrow button, the temperature will decrease 1º until it
reaches 64°F (18ºC).
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Indicator light on air conditioner will flash.
2. Press the up arrow or down arrow button to change delay
time (1 to 24 hours).
3. Press TIMER again or wait 10 seconds. Indicator light on air
conditioner will remain on.
To set Timer to turn on air conditioner, keeping previous
settings:
1. Turn off air conditioner.
2. Press TIMER. Indicator light on air conditioner will flash.
3. Press the up arrow or down arrow button to change delay
time (1 to 24 hours).
4. Press TIMER again or wait 10 seconds. Indicator light on air
conditioner will remain on.
To set Timer to turn on air conditioner, changing the
previous settings:
1. Turn on air conditioner.
2. Adjust MODE to Auto, Cool, Fan Only, or Power Saver.
3. Adjust FAN SPEED to Turbo, High or Low.
4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Indicator light on air conditioner will flash.
7. Press the up arrow or down arrow button to change delay
time (1 to 24 hours).
8. Press TIMER again or wait 10 seconds. Indicator light on air
conditioner will remain on.
Turbo
High
FAN
Low
Timer