Unpack the Air Conditioner
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
Remove packaging materials
Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
SMART-MOUNT
INSTALLATION INSTRUCTIONS
™
Tray Installation
1. Using the tray back as a template, center in windowsill
against outside edge of stool.
1. Tray back
2. Windowsill
3. Outside edge of stool
2. Using the 2 inside screw holes in tray back, mark screw
locations on windowsill for mounting the SMART-MOUNT
tray.
3. Remove tray back. Using these marks, drill
in the windowsill approximately 1
4. To assemble the tray frame, insert tab on tray back into slot
on tray side. Check to see that the tab is engaged and the
2 pieces are aligned. Insert 2 - #8 - 18 x
screws to secure.
5. Repeat with other tray side.
2
1
1. Tray back
2. #8 - 18 x
3. Tray side
in. pilot holes
in. deep.
in. hex-head
3
in. hex-head screws
™
5