Prepare Air Conditioner For Installation - Whirlpool 1187361 Use And Care Manual

Install in window
1. From inside, place SMART-MOUNT
down, in the window. Match the holes in tray side with the
predrilled holes in windowsill.
2. Using 2 - #10 - 12 x 1
the tray-frame assembly to the window.
1
1. #10 - 12 x 1 in. slot-head wood screws
NOTE: If the exterior of building can be damaged by support
legs, place a board between the wall and support legs.
3. With tray center pushed away from the windowsill, place a
level on the angled edge of tray side. Check to be sure level is
against notch on tray side. Adjust SMART-MOUNT
bubble indicates level.
1. Place level on angled edge
against notch on tray side
4. Tighten the hex nut just enough to hold tray center in place.
5. Repeat with other side.
6. Tighten hex nuts securely with
™ tray, support legs facing
in. slot-head wood screws, secure
™
1
in. wrench.

Prepare Air Conditioner for Installation

1. Locate provided bag of pan-head screws.
2. Place the top channel on top of the air conditioner, lining up
the holes in top channel with the holes on top of air
conditioner.
3. Using 3 - #10 x
air conditioner.
Install side curtains
NOTE: Attach curtains to unit before placing unit in window.
1. Insert curtain into curtain frame. Make sure the curtain end
tray until
locks into curtain frame.
2. Push curtain in all the way.
in. pan-head screws, attach top channel to
2
1
1. Top channel
2. #10 x in. pan-head screw
7