Table of Contents
Advertisement
Stand-alone node set-up
............................................................................................................................................................................................................................................................
Software installation
Description
Installation of the (Alcatel-Lucent 1850 TSS-5) software and WaveStar
User Interface (GUI) software is covered in detail in the Alcatel-Lucent 1850 Transport
Service Switch (TSS-5) Software Release Description, which is provided with the software
CD. On this CD, is software for the VLNC2, VLNC50, VLNC52, VLNC35, and the
following CLI (Command Line Interface) packs VLNC40, VLNC42, VLNC60, VLNC61
and the VLNC64.
Installing the WaveStar
necessary for software loading of the VLNC2, VLNC35, VLNC50, VLNC52, VLNC40,
VLNC42, VLNC60, VLNC61, and VLNC64 circuit packs. Follow the procedure "Install
software on the PC" section of the Alcatel-Lucent 1850 Transport Service Switch (TSS-5)
Software Release Description.
Any provisioning other than the software download, to the VLNC40, VLNC42,VLNC60,
VLNC61, and VLNC64 will be done through the use of the CLI and its associated
documentation. To install the Network Element software on the VLNC2, VLNC35,
VLNC50, VLNC52, VLNC40,VLNC42,VLNC60, VLNC61, VLNC64, and CIT, please
follow the procedures in the "Install NE software on a new Network Element" section
of the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Software Release
Description.
Important!
check off the appropriate box in
Software installation
Software installation is accomplished by performing the "Install NE software on a new
Network Element" section in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5)
Software Release Description which is shipped with the software CD. Software download
requires an MS-DOS compatible personal computer (PC), and either a CIT interface cable
for connecting the PC to the RS232 connector on the faceplate of the VLNC2 circuit pack
or a LAN cross-over or straight cable for connecting the PC's network card to the LAN
connector on the faceplate of the VLNC2 (preferred).
Software installation for the CLI circuit packs VLNC40, VLNC42, VLNC60, VLNC61.
VLNC64 is accomplished by either using the RS-232 connector designated M1 or M2 for
main1 and main2 on the VLIU I/O board or connecting a staight or cross over cable
directly to the LAN port of the card and using the TFTP server to download the pack.
Refer to "Install NE software on a new Network Element" section of the SRD for
complete details
............................................................................................................................................................................................................................................................
365-372-403R5.1
Issue 1 November 2008
®
CIT software and the TFTP software from this CD to the PC is
When the software installation is completed for all applicable packs
Table II-1, "Part II installation checklist" (p.
Software installation
®
CIT Graphical
II-1).
5 - 9
Advertisement
Table of Contents
