Table of Contents
Advertisement
Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
VLNC50 main1 or main2 installation
Follow this procedure to install the VLNC50 OC-3/STM-1/OC12/STM-4/1GbE circuit
pack in the Alcatel-Lucent 1850 TSS-5 shelf.
........................................................................................................................................................................................................................
1
Remove the VLNC50 circuit pack from the packing material.
........................................................................................................................................................................................................................
2
Identify the large, lower left hand slot on the Alcatel-Lucent 1850 TSS-5 shelf. See
Figure 4-1, "Rack-mount Alcatel-Lucent 1850 TSS-5 shelf front view" (p.
........................................................................................................................................................................................................................
3
Holding the Main VLNC50 circuit pack upright in your hand, turn the circuit pack 90
degrees to the right and place the Main OLIU circuit pack into slot 1 or 2 on the Rack-
Mount Alcatel-Lucent 1850 TSS-5 shelf. Do NOT engage the circuit pack in the
backplane connector.
Note:
Interface board. If Main 2 slot is to be equipped, repeat steps 1 to 3 otherwise install a
199MN apparatus blank to provide proper air flow for cooling. Refer to
apparatus blank installation (p.
........................................................................................................................................................................................................................
4
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
VLNC52 main1 or main2 installation
Follow this procedure to install the OC-3/STM-1 & OC-12/STM-4 HS w/ 28 DS1/E1,
3DS3/E3, & 1 GigE (pluggable optics ready) circuit pack in the Alcatel-Lucent 1850 TSS-
5 shelf.
........................................................................................................................................................................................................................
1
Remove the VLNC52 circuit pack from the packing material.
............................................................................................................................................................................................................................................................
4 - 4
S
F
T E P S
The VLNC50 can occupy both Main slots if equipped with any VLIU
S
F
T E P S
Table I-1, "Part I installation checklist" (p.
4-10).
Table I-1, "Part I installation checklist" (p.
Initial circuit pack installation
I-3).
4-2).
199MN
I-3).
365-372-403R5.1
Issue 1 November 2008
Advertisement
Table of Contents
