Ds3/E3 Access Panel Connectors - Alcatel-Lucent 1850 Installation And System Turn-Up Manual

Cable and fiber installation
............................................................................................................................................................................................................................................................
Figure 3-7 DS3/E3 access panel connectors
Procedure
Proceed as follows:
........................................................................................................................................................................................................................
1
Refer to engineering job specification. Obtain the DS3/E3 cables per
"DS3/E3/E3 cable assemblies" (p.
direction (IN or OUT of the bay) at each end.
........................................................................................................................................................................................................................
2
Connect the BNCs at each end. Mini BNCs connect to the DS3/E3 Access Panel. Refer to
Table 3-7, "DS3/E3 access panel connectors" (p. 3-11)
DS3/E3 1,2 or 3.
........................................................................................................................................................................................................................
3
If necessary attach a 3" tie bar to the front of the Alcatel-Lucent 1850 TSS-5 shelf above
the circuit pack slots and just above the top of the VLIU in use. This will allow the front
cover to close.
........................................................................................................................................................................................................................
4
Are you terminating the DS3/E3 cables on a DSX?
IF...
Yes
No
............................................................................................................................................................................................................................................................
365-372-403R5.1
Issue 1 November 2008
3-10). Label the cables, indicating bay and shelf and
Then...
Go on to Step 5
Skip to Step 8
DS3/E3 cable Installation
Table 3-5,
for correct placement, IN or OUT,
3 - 1 1