............................................................................................................................................................................................................................................................

pack. If there is not an established cross-connection for the port under test, enter one with

the following command.

At the NE system view screen, under Configuration, select Cross-Connection.

Result:

connect.

Select enter new cross-connection, and enter next at bottom of screen.

Select the rate of the cross-connection (STS1), (VC3), and enter next.

Select UPSR/SNCP Ring Add/Drop and select next.

The next screen will have you select the Main tributary of your cross-connection (A).

Select the "+" sign next CP main-1 (OC-N/STM-N) select Port 1 (OCN/STM-N).

Highlight an available tributary on the right-hand side and select next (m-1-1).

Select the DS3/E3 to drop to (GRP grp-b-1). Choose the port under test port 1 (b-1 or E3).

Highlight the available port tributary on the right-hand side.

Click Select.

Click Next.

Select Finish from the bottom of screen.

Result:

Requirement:

6 - 1 8

The cross-connect wizard will open and guide you through setting up a cross-

A cross-connection is established from m1-1 to b-1 or E3.

The DS3/E3 test set will indicate it is receiving an error-free signal.

Local equipment and cross-connect tests

Issue 1 November 2008

365-372-403R5.1

Table of Contents

Alcatel-Lucent 1850 Installation And System Turn-Up Manual page 144

Related Manuals for Alcatel-Lucent 1850

Related Products for Alcatel-Lucent 1850

Table of Contents