Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
10
Login into the Alcatel-Lucent 1850 TSS-5 shelf using the following values;
Result:
........................................................................................................................................................................................................................
11
Enter user privilege mode by entering an "e" at the (ALU 1850TSS-5) prompt.
........................................................................................................................................................................................................................
12
Enter a <CR> at the password prompt.
Result:
........................................................................................................................................................................................................................
13
Enter the CLI command show network.
Result:
echoed back. The IP address Subnet Mask and Default Gateway will be 0.0.0.0.
If nothing is echoed back, make sure you are logged in the privilege mode and a "#"
sign follows the prompt.
........................................................................................................................................................................................................................
14
Enter the following CLI command to set up the network IP address; network parms
10.10.10.1 255.255.255.0.
........................................................................................................................................................................................................................
15
Enter the CLI command show network.
Result:
back.
........................................................................................................................................................................................................................
16
Enter the CLI command show network.
........................................................................................................................................................................................................................
17
Enter the CLI command write memory to save these settings.
............................................................................................................................................................................................................................................................
6 - 2 4
Prompt
User:
Password:
The default system prompt (ALU 1850TSS-5) > will be echoed back.
The default system prompt (ALU 1850TSS-5)# will be echoed back.
The IP address, Subnet Mask, Default Gateway, MAC address, etc. will be
The IP Address =10.10.10.1 and Subnet Mask 255.255.255.0 will be echoed
Local equipment and cross-connect tests
Value
Admin
blank
365-372-403R5.1
Issue 1 November 2008
Advertisement
Table of Contents
