Alcatel-Lucent 1850 Installation And System Turn-Up Manual page 110

Transport service switch (tss-5) | release 5.1
Hide thumbs Also See for 1850:
Table of Contents

Advertisement

Stand-alone installation tests
............................................................................................................................................................................................................................................................
PC and cable requirements for WaveStar
This section lists the required and optional equipment needed to run the WaveStar
software with the Alcatel-Lucent 1850 TSS-5.
Quantity
1
1
1
PC minimum requirements for WaveStar
Windows 2000 or Windows XP Operating Systems
256 MByte of RAM (minimum), 512 MByte recommended
139 MByte Virtual Memory (minimum), 267 MByte recommended.
SVGA monitor set to 800x600 resolution or greater, with 256 colors (1024x768, 16
million colors recommended)
650 MByte memory available on hard drive (minimum), 750 MByte Recommended
(for all graphical packages).
CD-ROM drive
10/100 BaseT LAN interface (network interface card, NIC)
Pentium II, 266 MHz Processor (minimum), Pentium IV, 1 GHz recommended.
Important!
recommended requirements may run multiple (up to 4) System GUI views, unless
otherwise noted. Recommended requirements are intended to be used as a general
guideline to optimize WaveStar
............................................................................................................................................................................................................................................................
II - 4
®
CIT
Required
Description
Y
Personal computer (PC)
Y
CIT interface cable
(848748869)
Y
LAN 10BASE-T
(Crossover)
LAN 10BASE-T (straight
through)
Minimum requirements are sufficient to run one System GUI view the
Comments
See
WaveStar
below.
8-ft. long RJ45 to 9-pin D-sub serial
cable.
Allows for direct connection between
the PC LAN card and either the
VLNC40 MGMT LAN Port, or the
VLNC60 LAN or the CTL LAN slot.
See
(p. 3-35)
Allows for connection between the PC
NIC card and a HUB. See
"LAN straight-through cable
connections" (p. 3-36)
information.
®
CIT installation
®
CIT performance. As the CIT is used with multiple
"PC minimum requirements for
®
CIT installation" (p. 4-4)
Table , "LAN cable installation"
for Comcode information.
Table 3-21,
for Comcode
365-372-403R5.1
Issue 1 November 2008
®
CIT

Advertisement

Table of Contents
loading

Table of Contents