Cisco ONS 15454 ETSI Manual page 86

NTP- G35 Inspect the Shelf Installation and Connections
If you installed an ONS 15454 ANSI shelf, complete
Step 2
procedure was completed.
Table 1-13
Description
NTP-G1 Unpack and Inspect the Shelf Assembly, page 1-6
NTP-G2 Install the Shelf Assembly, page 1-8
NTP-G3 Open and Remove the Front Door, page 1-21
NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-28
NTP-G7 Install the Power and Ground, page 1-32
NTP-G8 Install the Fan-Tray Assembly, page 1-42
NTP-G9 Install the Alarm Expansion Panel (ANSI Only), page 1-46
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
1-49
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only), page 1-60
NTP-G13 Install the Rear Cover (ANSI Only), page 1-65
NTP-G14 Install DWDM Equipment, page 1-67
NTP-G15 Install the Common Control Cards, page 1-75
NTP-G145 Connect a Multishelf Node and Subtending Shelves to an MS-ISC-100T
Card, page 1-81
to a Catalyst 2950, page 1-83
NTP-G159 Configure a Cisco Catalyst 2950 for a Multishelf Node, page 1-83
completed
Catalyst 2950, page
Complete the
Step 3
Complete the
Step 4
Continue with
Step 5
Stop. You have completed this procedure.
DLP-G35 Inspect the Shelf Installation and Connections
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Procedure Guide, R8.0
1-86
ONS 15454 ANSI Shelf Installation Task Summary
or NTP-G158 Connect a Multishelf Node and Subtending Shelves
NTP-G158 Connect a Multishelf Node and Subtending Shelves to a
1-83)
"DLP-G35 Inspect the Shelf Installation and Connections" task on page
"DLP-G36 Measure Voltage" task on page
Chapter 2, "Connect the PC and Log into the GUI."
Use this task to inspect the shelf installation and connections and verify that
everything is installed and connected properly.
None
Required
Onsite
None
Chapter 1 Install the Shelf and Common Control Cards
Table 1-13 by verifying that each applicable
(if you
1-87.
Completed
1-86.
78-17704-02