Cisco ONS 15454 ETSI Manual page 6

NTP- G1 Unpack and Inspect the Shelf Assembly
•
Ring runs are not provided by Cisco and can hinder side-by-side shelf installation where space is limited.
Note
Tools Needed (ETSI)
To install the ONS 15454 ETSI, you need the following tools.
•
•
•
•
•
•
•
Test Equipment (ETSI)
To install the ONS 15454 ETSI, you need the following test equipment.
•
•
•
NTP-G1 Unpack and Inspect the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Procedure Guide, R8.0
1-6
Wire cutters
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Video fiber connector inspection instrument
CLETOP cleaning cassette
Crimping tool—This tool must be large enough to accommodate the girth of the grounding lug when
you crimp the grounding cable into the lug.
Wire stripping tool
Voltmeter
Power meter (only for use with fiber optics)
BER tester for E1-N-14, E1-42, E3-12, DS3i-N-12, STM1E-12, and FMEC cards
This procedure explains how to unpack the ONS 15454 shelf assemblies
and verify their contents.
Pinned hex (Allen) key for front door
Required
Onsite
None
"DLP-G1 Unpack and Verify the Shelf Assembly" task on page
"DLP-G2 Inspect the Shelf Assembly" task on page
"NTP-G1 Unpack and Inspect the Shelf Assembly" procedure on page
Chapter 1 Install the Shelf and Common Control Cards
1-7.
1-7.
1-6.
78-17704-02