Cisco ONS 15454 ETSI Manual page 48

NTP- G9 Install the Alarm Expansion Panel (ANSI Only)
Figure 1-22
Insert and tighten three screws to secure the AEP to the backplane.
Step 4
Connect the AEP cable to the backplane and AEP:
Step 5
Connect the 10 colored wires to the wire-wrap pins on the backplane.
a.
cable wires are connected.
Plug the other end of the AEP cable into AEP connector port.
b.
Figure 1-23
Cisco ONS 15454 DWDM Procedure Guide, R8.0
1-48
Installing Standoffs and the AEP
Wires
AEP cable
Connector
Table 1-2
AEP Wire-Wrap Connections to Backplane Pins
Chapter 1 Install the Shelf and Common Control Cards
shows AEP and AIC-I signals that each wire carries.
Figure 1-23 shows where the
78-17704-02