Cisco ONS 15454 ETSI Manual page 58

NTP- G25 Install LAN Wires on the Backplane (ANSI Only)
Note
Return to your originating procedure (NTP).
Step 2
DLP-G25 Install LAN Wires on the Backplane (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Rather than using the LAN wires, you can use the LAN connection port on the TCC2/TCC2P if
Note
preferred. Use either the backplane connection or the TCC2/TCC2P front connection. You cannot use
the LAN backplane pins and the LAN connection port on the TCC2/TCC2P simultaneously; however, it
is possible for you to make a direct connection from a computer to the LAN connection port on the
TCC2/TCC2P while the LAN backplane pins are in use as long as the computer that is connected directly
to the TCC2/TCC2P is not connected to the same LAN.
Step 1 Using #22 or #24 AWG (0.51 mm² or 0.64 mm²) wire or CAT-5 Ethernet cable, wrap the wires on the
appropriate wire-wrap pins according to local site practice.
Cross talk might result if both receive (Rx) and transmit (Tx) pins connect on the same twisted pair of
Caution
wires from the CAT-5 cable. The two Tx pins need to be on one twisted pair, and the two Rx pins need
to be on another twisted pair.
A frame ground pin is located beneath each pin field (FG2 for the LAN pin field). Wrap the ground shield
of the LAN interface cable to the frame ground pin.
Table 1-7
Pin Field
LAN 1
Connecting to DCE (a hub
or switch); The ONS 15454
ANSI is a DCE.
Cisco ONS 15454 DWDM Procedure Guide, R8.0
1-58
For more detailed information about timing, refer to the "Timing" chapter in the
Cisco ONS 15454 DWDM Reference Manual. To set up system timing, see the
Up Timing" procedure on page
This task installs the LAN wires on the ONS 15454 ANSI backplane.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) wire, preferably CAT-5
As needed
Onsite
None
LAN Pin Assignments for the ONS 15454 ANSI Shelf
Backplane Pins
B2
A2
B1
A1
Chapter 1 Install the Shelf and Common Control Cards
6-4.
Table 1-7 shows the LAN pin assignments.
RJ-45 Pins
1
2
3
6
"NTP-G53 Set
Function/Color
TX+ white/green
TX– green
RX+ white/orange
RX– orange
78-17704-02