File Name Entry; Fax Direct Transmission; Cancelling Direct Transmission; Send And Print - Kyocera Fax System 10 Operation Manual

Sending Faxes > File Name Entry

File Name Entry

Adds a file name.
Additional information such as job number and date and time can also be set. You can check a job history or job status
using the file name, date and time, or job number specified here.
Enter the file name (up to 32 characters).
To add date and time, select [Date and Time]. To add job number, select [Job No.]. To add both, select [Job No.] &
[Date and Time] or [Date and Time] & [Job No.].

Fax Direct Transmission

The destination is dialed and communication starts before the original is scanned, allowing you to verify that each page
of the fax has been properly sent.
Setting for Direct transmission
On
Off
NOTE
In direct transmission, you can designate only one destination for one transmission.
In the destination screen for sending, select [Direct]. This selects the direct transmission method and the keys on the
touch panel are highlighted.

Cancelling Direct Transmission

During direct transmission, to cancel communication during transmission, select the [Stop] key on the operation panel or
[Cancel] on the touch panel. The originals that have been scanned are ejected, and the screen returns to the send
default screen. When originals remain in the document processor, take them out.
NOTE
In some cases, transmission may take place even if the [Stop] key or [Cancel] is selected.

Send and Print

Prints a copy of the document being sent.
Item
Off
On
Starts direct transmission.
Dials the receiving system, and after the communication has started, originals
are scanned.
Starts memory transmission.
After originals are scanned into memory, the communication starts.
Does not print a copy of the document being sent.
Prints a copy of the document being sent.
3-29
Description
Description