Chapter 1 Introduction; Safety Messages; Symbols - Emerson AMS Wireless Vibration Monitor User Manual

User Guide
MHM-97927-PBF
1 Introduction
1.1

Safety messages

Instructions in this manual may require special precautions to ensure the safety of the
personnel performing the operations.
The AMS Wireless Vibration Monitor complies with Part 15 of the FCC Rules. Operation is
subject to the following conditions:
This device may not cause harmful interference, this device must accept any interference
received, including interference that may cause undesired operation.
This device must be installed to ensure a minimum separation of 20 cm from all persons.
Refer to the following safety messages before performing an operation preceded by the
warning symbol:
WARNING
Failure to follow these installation guidelines can result in death or serious injury. Only
qualified personnel should install the AMS Wireless Vibration Monitor.
Explosions could result in death or serious injury:
• Before connecting a Field Communicator in an explosive environment, make sure the
instruments are installed in accordance with applicable field wiring practices.
• Verify that the operating environment of the AMS Wireless Vibration Monitor is
consistent with the appropriate hazardous locations certifications.
1.2

Symbols

Note
This symbol marks passages that contain important information.
CAUTION
This symbol marks operations that can lead to malfunctions or faulty measurements, but
will not damage the device.
DANGER
This symbol indicates actions that can lead to property damage or personal injury.
The symbols on the device signify compliance to the following:
MHM-97927-PBF, Rev 1
Ukraine Restriction of Hazardous Substances (RoHS)
Introduction
August 2020
5