Pre-Configuration - Emerson AMS Wireless Vibration Monitor User Manual

Configuration
August 2020
2.2

Pre-configuration

The AMS Wireless Vibration Monitor is shipped with the battery disconnected from the
device to comply with safety requirements. You need to connect the battery before you
can configure the device. Remove the battery after configuration to avoid depleting it.
Procedure
1. Use your hands to unscrew and remove the blue cover.
2. Remove the battery with the pull tab.
3. Locate the battery connector and plug it into the socket on the device as shown.
16
Note
This setup is recommended for standard device configuration.
This exposes the HART ports.
Use an Allen wrench or a small screwdriver and put it through the Orientation hole
to use as leverage while loosening the cover.
CAUTION
Exercise caution when using your bare hands to remove the cover.
User Guide
MHM-97927-PBF
MHM-97927-PBF, Rev 1