Emerson AMS Wireless Vibration Monitor User Manual page 46

Installation
August 2020
Procedure
1. If the equipment surface has a radius of curvature that is less than 4 in. (100 mm),
2. Using a wire brush and plant-approved cleaner, clean and degrease the surface
3. Using a two-part epoxy (such as Emerson P/N A92106)), spray the activator onto
4. Ensure that the mounting pad / base of the device is grounded to the machine case.
5. Use a multimeter to check conductivity between the mounting pad and machine
3.3.3 Triaxial quick connection
Use this mount in scenarios where there is a need to remove the monitor from the
machine but you also need a more permanent type of installation. This mounting
mechanism has two components: the receptacle that attaches to the device and the base
that attaches to the machine. The base itself comes in two options: epoxy mounted, or
stud mounted.
Procedure
1. Find the right location for the base. Make sure that the base notch is oriented with
2. Install the device on the receptacle and orientate the whole assembly together.
3. Install the base on the machine using either
4. Align the notch on the receptacle with the notch on the base and give it a ¼ turn. It
3.3.4 Motor fin mounting
Procedure
1. Prepare cooling fins on motor for mounting by scraping or grinding any paint or
2. Clean mounting area with a spray degreaser that will not leave a thin fil lubricating
3. Mix adhesive.
4. Apply adhesive to the sides and the bottom of the probe portion of the motor fin
46
grind a flat surface approximately 0.5 in. (12.7 mm) in diameter.
area.
the mounting surface. Place a light coat of epoxy on the surface of the mounting
pad and hold firmly against the machine spot face surface for one minute.
Note
If the adhesive does not set within 1 minute, it indicates that too much epoxy is
applied or that the mounting surface is not prepared properly. Repeat steps 2–3.
Use a two-part conductive epoxy (such as Loctite Ablestik 2902) and make a bead
that bridges the mounting pad to the machine case.
surface.
either the X or the Y axis of the device.
mounting (alternative).
will lock in the same place every single time.
debris between cooling fins.
residue.
mount probe/pad (the area is roughened to enhance the bonding area).
Stud mounting (preferred)
MHM-97927-PBF, Rev 1
User Guide
MHM-97927-PBF
or Epoxy