Verify Operation With Ams Trex Communicator - Emerson AMS Wireless Vibration Monitor User Manual

Operation
August 2020
2. On the Devices page, click + beside a tag name to display more information about
3. Verify the Network ID and Join Key in the device match those found on the Emerson
4.3

Verify operation with AMS Trex Communicator

You can verify the status of the AMS Wireless Vibration Monitor and configure it using an
AMS Trex Communicator. For instructions on using the AMS Trex unit, see the User Guide.
Note
HART Wireless transmitter communication requires a AMS Wireless Vibration Monitor
Device Descriptor file (DD). Refer to the Field Communicator User's Manual for more
details on DDs or go to
Communicator/Pages/SysSoftDDs.aspxhttps://www.emerson.com/en-us/catalog/ams-
trex-device-communicator
Monitor.
Table 4-1: Field Communicator menu
Menu
Guided Setup
Manual Setup
52
the device.
Wireless Gateway:
a. From the Emerson Wireless Gateway, click System Settings → Network →
Network Settings.
b. Verify Show join key has a check mark.
Note
The most common cause of incorrect operation is that the Network ID or Join Key
are not set correctly in the device.
http://www2.emersonprocess.com/en-US/brands/Field-
for instructions on adding a DD for AMS Wireless Vibration
Submenu
Configure Variable Mapping
Configure Device Variable Units
Configure Alert Limits
Configure Acquisition Settings
Join Device to Network
Configure Update Rate
Wireless
Machine
Z Axis
X-Y Axis
Interval Bands
General
Mapping
Device Information
License
User Guide
MHM-97927-PBF
MHM-97927-PBF, Rev 1