Appendix B Product Certifications; Approved Manufacturing Locations; Wireless Certifications - Emerson AMS Wireless Vibration Monitor User Manual

User Guide
MHM-97927-PBF
B Product certifications
Note
For specific device certifications, always refer to the product nameplate and markings on
the device.
B.1

Approved manufacturing locations

Emerson
835 Innovation Drive
Knoxville, TN 37932 USA
T: +1 865-675-2400
Benchmark Electronics (Thailand) Plc.
109 moo.4, Chaimongkol, Muang, Nakorn Ratchasima
Thailand 30000
T: +66 44-233-800
B.2

Wireless certifications

Telecommunications compliance
All wireless devices require certification to ensure that they adhere to regulations
regarding the use of the RF spectrum. Nearly every country requires this type of product
certification. Emerson works with governmental agencies around the world to supply fully
compliant products and remove the risk of violating country directives or laws governing
wireless device usage.
Radio Equipment Directive (2014/53/EU)
Emerson complies with the Radio and Equipment Directive.
FCC approvals
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to a radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
MHM-97927-PBF, Rev 1
Product certifications
August 2020
73