Land Pride SB10 Series Operator's Manual page 25

Section 3: Tractor Hook-up & Unhook
47298
4. Connect electric motor (chute rotation) and electric
actuator (deflector angle) to the control box as
follows:
Electric Motor
Plug chute rotation wire harness (#7) to the red &
black terminal (#6). Verify opposite end of wiring
harness is plugged to the electric motor.
Electric Actuator
Plug deflector wire harness (#8) to the white & black
terminal (#5). Verify opposite end of wiring harness
is plugged to the electric actuator.
5. Check routing of wire harness (#7 & #8) to make
certain they will not become pinched or pulled apart.
Tie harness to Snow Blower and tractor as needed
with cable ties. Cable ties are supplied by customer.
Unhook Snow Blower
1. See "Long-Term Storage" on page 34 before
parking Snow Blower for a long period.
2. Disengage power take-off, park on a level solid
surface, and lower Snow Blower to ground level.
3. Place gear selector in park or in neutral with park
brake set, shut engine off, remove switch key, and
wait for power take-off to stop before dismounting
tractor.
4. Hydraulic Options:
a. With tractor shut off, move hydraulic control
levers back and forth several times to relieve all
hydraulic pressure in hydraulic hoses.
b. Disconnect hydraulic hoses from tractor duplex
outlets.
c. Wrap hydraulic hoses around Snow Blower hitch
frame for storage and to keep dirt away from quick
disconnect couplings.
1/23/19
Table of Contents
Driveline Installation (Shown with 3-Point Hitch Fully Extended)
SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Figure 3-8
Refer to Figure 3-7 on page 20:
5. Electrical Options:
a. Disconnect electric motor (chute rotation) wiring
harness (#7) from control box (#1). Coil harness
up and tie to Snow Blower hitch frame.
b. Disconnect electric actuator (deflector wiring
harness (#8)) from control box (#1). Coil harness
up and tie to Snow Blower hitch frame.
c. Disconnect black negative (-) wire lead (#11) from
power source.
d. Disconnect red positive (+) lead (#10) from power
source.
e. Remove control box (#1) from tractor, wrap wiring
harness (#13) up in a coil and tie coils together to
keep coils from unwrapping.
f. Store wiring harness (#13) and control box (#1) in
a dry location.
Refer to Figure 3-8:
6. Pull back on driveline pull collar (#8) and hold while
pulling driveline yoke from tractor power take-off
shaft.
7. Remove top center hitch pin keeper and hitch pin. If
provided, place center 3-point link in tractor's holding
clip.
8. Remove linchpins (#5) and hitch pins (#1) from lower
3-point lift arms.
9. Drive tractor forward several feet. Place gear selector
in park or set park brake, shut tractor engine off,
remove switch key, and dismount tractor.
10. Reinstall hitch pins, linchpins, and hair pin cotters in
the Snow Blower hitch for safe keeping.
11. Collapse driveline (#7) by pushing tractor end of
driveline towards the Snow Blower.
12. Support collapsed driveline off the ground to keep
dirt away from yoke pull collar and bearings.
37095
21