Land Pride SB10 Series Operator's Manual page 12

Section 1: Standard Assembly & Set-up
Section 1: Standard Assembly & Set-up
Tractor Requirements
Tractor horsepower and hitch category should be within
the range noted below. Tractors outside the horsepower
range must not be used.
Tractor horsepower rating
SB10 Series . . . . . . . . . . . . . . . . . . . . . 18 to 32 hp
SB15 Series . . . . . . . . . . . . . . . . . . . . . . . 30-59 hp
SB25 Series . . . . . . . . . . . . . . . . . . . . . . 43-105 hp
Hitch type:
SB10 Series . . . . . . . . . . . . . . . . . . . . 3-Point Cat. I
SB15 Series . . . . . . . . . . . . . . . . . . . . 3-Point Cat. I
SB25 Series . . . . . . . . . . . . . . . . . 3-Point Cat. I & ll
Power take-off speed . . . . . . . . . . . . . . . . . . 540 rpm
Hydraulic quick disconnect outlets (Optional)
Chute rotational adjustment. . . . . . . . .Duplex outlet
Deflector angle adjustment . . . . . . . . .Duplex outlet
Tractor weight . . . . . . . . . . . . . . . . See warning below
!
WARNING
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator's Manual to determine proper
weight requirements and maximum weight limitations.
Torque Requirements
Refer to "Torque Values Chart" on page 40 to
determine correct torque values for common bolts. See
"Additional Torque Values" at bottom of chart for
exceptions to standard torque values.
The following are basic power machine shutdown
procedures. Follow these procedures and any additional
shutdown procedures provided in your power machine
Operator's Manual before leaving the operator's seat.
1. Reduce engine speed and shut-off all power to the
attachment.
2. Park on solid, level ground and lower attachment until
it is flat on the ground or on non-concrete support
blocks.
3. If shutting down a tractor, put tractor in park or set
park brake.
4. Turn off engine, and remove switch key to prevent
unauthorized starting.
5. Relieve all hydraulic pressures.
6. If included, raise seat bar and move controls until
both lock.
7. Wait for all components to come to a complete stop
before leaving the operator's seat.
8. Use steps, grab-handles, and anti-slip surfaces
when stepping on and off the power machine.
8
SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Table of Contents
Dealer Set-up Instructions
When included, it is simpler to assemble the optional
outer skid shoes or outer wear bars before removing the
shipping crate. See "Skid Shoes, Outer" or "Wear Bars,
Outer" on page 14 for detailed installation instructions.
Loading & Unloading
Refer to Figure 1-1:
There are two lifting holes (one on each end panel).
These lift holes are provided for attaching a lift chain to
the Snow Blower during loading and unloading.
Lift Points
Figure 1-1
37081
1/23/19