Land Pride SB10 Series Operator's Manual page 18

Section 2: Optional Assembly & Set-up
Wear Bar, Lower
Refer to Figure 2-10:
1. Attach lower wear bar (#1) to bottom of Snow Blower
frame with 3/8"-16 x 1" GR5 plow bolts (#2) and hex
flange locknuts (#3).
2. Tighten locknut to the correct torque.
Wear Bars, Outer
Refer to Figure 2-11:
1. Attach outer wear bars (#1) to the side panels by
inserting 3/8"-16 x 1 1/4" GR5 carriage bolts (#2)
through lower square holes in outer wear bars and
lower mounting holes in side panels.
2. Secure bolts with hex flange locknuts (#3). Tighten
locknuts to the correct torque.
14
SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Table of Contents
Lower Wear Bar Assembly
Figure 2-10
37091
37090
Outer Wear Bar Assembly
Figure 2-11
1/23/19