Section 3: Tractor Hook-Up & Unhook - Land Pride SB10 Series Operator's Manual

Section 3: Tractor Hook-up & Unhook
37298
4. Return to the tractor. Slowly and carefully raise and
lower Snow Blower to ensure drawbar, tractor tires,
and other equipment on the tractor do not come in
contact with the Snow Blower. If necessary, move or
remove tractor drawbar.
Driveline Hook-Up
Refer to Figure 3-2:
!
DANGER
To avoid serious injury or death:
• Do not engage power take-off while hooking-up or
unhooking the driveline, or while someone is standing near
the driveline. A person's body and/or clothing can become
entangled in the driveline.
All guards and shields must be installed and in good
•
working condition while operating the implement.
• Do not use a power take-off adapter. The adapter will
increase strain on the tractor's power take-off shaft causing
possible damage to shaft and driveline. It will also defeat
the purpose of the tractor's power take-off shield.
!
WARNING
To avoid serious injury or death:
• Always shut tractor down using "Tractor Shutdown
Procedure" provided in this manual before allowing anyone
including the operator to hook-up and unhook implement.
• Check driveline when lowering implement to make sure it
does not interfere with the tractor drawbar. If needed, shut
tractor off and move or remove drawbar to prevent driveline
damage.
IMPORTANT: Check driveline collapsible and
maximum length before completing "Driveline
Hook-Up" instructions. Structural damage to the
tractor and implement can occur if these checks are
not made. Refer to "Check Driveline Collapsible
Length" on page 18 and "Check Driveline
Maximum Length" on page 19.
1/23/19
Table of Contents
Center 3-point hitch pin and hitch pin keeper are supplied by customer for all 3-point hook-ups.
Quick Hitch bushing is mounted in lower holes as shown
for standard 3-point & standard Quick Hitch hook-Up.
Driveline Installation (Shown with 3-Point Hitch Fully Extended)
SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Figure 3-2
IMPORTANT: An additional driveline may be
required if implement is attached to more than one
tractor or if a Quick Hitch is used.
IMPORTANT: The drivelines must be lubricated
before putting them into service. Refer to
"Lubrication Points" on page 35.
The driveline (#7) fastens to the tractor power take-off
shaft with a pull collar (#8).
1. If driveline collapsible length has not been checked,
go to "Check Driveline Collapsible Length" on
page 18. Otherwise, continue with step 2 below.
2. Park tractor and Snow Blower on a level surface.
3. Shut tractor down before dismounting. Refer to "The
following are basic power machine shutdown
procedures. Follow these procedures and any
additional shutdown procedures provided in your
power machine Operator's Manual before leaving
the operator's seat." on page 8.
4. If tractor drawbar interferes with the driveline during
hook-up, disconnect driveline and move drawbar
forward, to the side, or remove.
5. Pull back on driveline yoke collar and push driveline
yoke onto the tractor power take-off shaft. If driveline
is too long to push yoke onto the tractor power take-
off shaft, skip to "Check Driveline Collapsible
Length" on page 18.
6. Release pull collar and continue to push driveline
yoke forward until pull collar locks in place.
7. Move driveline yoke back and forth several times to
make sure yoke is locked in place.
37095
17