Land Pride SB10 Series Operator's Manual page 23

Section 3: Tractor Hook-up & Unhook
10. Cut off non-yoke end of outer driveline as follows:
a. Measure from end of outer shield to scribed mark
("Y" dimension) and record.
b. Cut off outer shield at the mark. Cut same amount
off the outer shaft ("Y1" dimension).
11. Remove all burrs and cuttings.
12. Continue with "Check Driveline Maximum Length"
on page 19.
24513
Outer Shielding has been removed for clarity.
Driveline Maximum Length
Figure 3-5
Check Driveline Maximum Length
Refer to Figure 3-5:
Driveline maximum length must, when fully extended,
have a minimum overlap of profile tubes by not less than
1/2 the free length with both inner and outer profile tubes
being of equal length.
1. Make sure "Check Driveline Collapsible Length" on
page 18 has been completed before continuing with
instructions below.
2. Unhook driveline profiles from the tractor and
implement.
3. If profiles are assembled together, pull outer and inner
drivelines profiles apart.
4. Measure and record "Free Length" of inner and outer
profiles as shown in Figure 3-5.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to "Lubrication
Points" on page 35.
5. Lubricate driveline u-joints, bearings, and profiles.
Refer to "Lubrication Points" on page 35.
6. Assemble driveline halves together until profile tubes
have exactly 1/2 profile overlap as shown.
7. Measure driveline "Maximum Allowable Length" and
record that length here ______.
8. Start tractor, raise implement slightly, and drive
forward enough to clear support blocks.
1/23/19
Table of Contents
9. Lower implement to ground and shut tractor down
before dismounting. Refer to "The following are
basic power machine shutdown procedures.
Follow these procedures and any additional
shutdown procedures provided in your power
machine Operator's Manual before leaving the
operator's seat." on page 8.
10. Continue with "Driveline Hook-Up" on page 17.
24872
Maximum Driveline Movement During Operation
Check Driveline Interference
Refer to Figure 3-6:
!
WARNING
To avoid serious injury or death:
A rotating driveline must not exceed an angle of 25 degrees up
or down, and never engage a driveline while at an angle
exceeding 25 degrees up or down. The driveline can break and
send projectiles.
1. Start tractor, raise implement fully up, and back
implement over the support blocks used to "Check
Driveline Collapsible Length" on page 18,
2. Without changing 3-point lift height, shut tractor
down before dismounting. Refer to "The following
are basic power machine shutdown procedures.
Follow these procedures and any additional
shutdown procedures provided in your power
machine Operator's Manual before leaving the
operator's seat." on page 8.
3. Check to make sure driveline does not exceed any of
the limits listed below:
•
Driveline does not exceed maximum allowable
length recorded in step 7 under "Check Driveline
Collapsible Length" on page 18.
•
Driveline angle does not exceed 25
horizontal or 25
4. If any limit was exceeded, adjust tractor 3-point lift
limiter to the height that will keep the driveline within
the recommended limit listed above.
5. If needed, repeat steps 1-4 until all limits mentioned
in step 3 are maintained.
SB1051, SB1064, SB1574, & SB2584 with S/N 881641+ Snow Blowers 370-430M
Figure 3-6
o
above
o
below horizontal.
19