Weekly Cleaning - Wells OC-2HG Operation Manual

PREPARATION
Allow oven to cool to 150ºF or less
FREQUENCY
Weekly
TOOLS
Fiber Brush, Plastic Scouring Pad, Plastic Scraper
Mild Detergent, Sanitizer,
Oven Cleaner, Clean Towel

WEEKLY CLEANING

1. Turn POWER SWITCH to FAN. With the door held open, allow the
oven to cool. When the oven interior has cooled to 150ºF or less,
turn the POWER SWITCH to OFF.
2. Remove racks and rack supports. Remove fan baffle.
3. Brush the fan wheel and wipe it with a moist cloth. Sponge out all
loose particles.
4. Scrub entire interior of convection oven with a plastic scouring pad
and oven cleaner.
5. For baked-on food spills, apply oven cleaner. Close the oven
door. Let stand for 10 minutes. Carefully wipe all oven cleaner
and food residue from all interior surfaces. Wipe with sanitizer.
6. Wipe down the entire interior using a clean cloth or moistened with
hot water and a mild detergent. Rinse by wiping with a clean towel
moistened with sanitizer.
IMPORTANT: Always wipe or rub in the direction of the polish
lines or grain of the metal.
7. Clean oven racks and rack supports in a sink or dishwasher.
8. Reinstall the fan baffle, paying particular attention that the lip on
the right side of the fan baffle is fully seated in the slot in the edge
of the oven cavity. Reinstall rack supports and racks.
IMPORTANT: Take care to avoid damage to fan blades when
reinstalling fan baffle.
9. Reconnect to electric power. Turn power switch to FAN .
Verify that fan runs smoothly and does not contact fan baffle.
Turn power switch to OFF. Reposition fan baffle if necessary.
10. Wipe down the exterior of the oven using a clean cloth moistened
with hot water and a mild detergent. A plastic scouring pad may be
used to removed baked-on food debris.
Rinse by wiping with a clean towel moistened with sanitizer.
IMPORTANT: Always wipe or rub in the direction of the polish
lines or grain of the metal.
11. Replace oven rack supports. Leave the door open overnight.
PROCEDURE IS COMPLETE
OVEN CLEANING INSTRUCTIONS (continued)
13
CAUTION:
ELECTRIC SHOCK
HAZARD
Disconnect appliance
from electric power before
cleaning.
CAUTION:
BURN HAZARD
Allow appliance to cool
completely before cleaning.
Do not attempt to clean the
oven until it has cooled to
150ºF or less. It can burn
you. Hand protection is
required.
CAUTION:
CUT HAZARD
FAN BLADES ARE SHARP.
Use due care when cleaning
and/or wiping.
IMPORTANT: DO NOT spill
or pour water into controls,
control panel or wiring.
Damage to internal
components from water
damage is not covered by
warranty.
Assembling Fan Baffle
& Rack Support