Advertisement
Program Cook Mode:
1.
Five programmable keys are provided f or presetting a time and temperature f
or each "PGM" key. To set the program, press and hold the appropriate "PGM"
key
(1—5) and turn the "Time" and "Temp" knobs to the desired time and temperature.
When the "PGM" key is released, the displayed time and temperature is stored
in memory.
2.
The program for any "PGM" key may be recalled and displayed by momentarily
pressing the "PGM" key.
3.
To start a cook cycle, press the appropriate "PGM" key and the "Start Timer"
key. Once the cook cycle has started, the program keys and rotary "Time" and
"Temp" knobs are locked out to prevent accidental re—programming.
4.
The actual oven temperature can be recalled by pressing the "Actual Temp" key.
5.
At the end of the cook cycle, an audible alarm will sound. Press the "Cancel"
key to shut of f the audible alarm.
Temperature Offset Mode:
A user preference offset mode is provided when you feel oven cooks is too hot or too
cold. This mode can be used to adjust oven controlling temperature by
increments. This adjustment affects the entire cooking range.
ACCESS:
1.
2.
3.
4.
5.
Preheat Instructions:
1.
Set the ON-OFF-FAN switch to the ON position. The red light will indicate that
the power is on.
2.
Turn -the thermostat knob to the desired temperature. The yellow light will
indicate that the heating elements are on.
3.
When the yellow light goes off, the oven has reached the desired temperature
and is ready for use.
CLEANING INSTRUCTIONS:
1.
Turn temperature control knob to the OFF position.
CAUTION:
2.
Wipe entire unit down using a clean cloth/sponge and soap/detergent with hot
water. For burned—on foods or sauce spillage, use an abrasive cleanser and
apply with stainless steel wool sponge.
IMPORTANT:
This same procedure may be applicable to darkened areas caused by oxidation.
3.
4.
Rinse unit with clean water and dry with a soft, clean cloth.
Set the time digits of the control to 00:00.
Set the temperature between 400° and 500°F.
Push and hold the start/timer key for 5 seconds.
Turn either rotary dial until desired off—set is
displayed.
Push the actual temp key to exit.
Make sure the oven has cooled down to
attempting to wipe the appliance clean.
Always rub in the direction of the polish lines or grain of
the metal.
150°
9
+1-
35F in
F or below before
50
Advertisement
