Updating Menu Files - Frymaster FilterQuick easyTouch FQG60T Service Manual

25. Cycle the fryer control power using the reset switch. This is located under the USB slot on the far-left side of the fryer (see
ENSURE THE SWITCH IS PRESSED AND HELD FOR 30 SECONDS. Failure to press and
Figure 58).
hold the reset switch long enough, may cause an incomplete software update.
26. While the fryer is rebooting some controllers may take a while to completely reboot as the software is loading.
27. Once all controllers have returned to the (OFF) power standby switch state.
fryer, prior to loading the MENU's, may disable the fryer!
28. VERIFY software update by pressing the home button; press the information (?) button; press the down arrow; press the
Software Version button. The controller displays INTIALIZING. Ensure that the software versions have updated to the correct
versions.
29. If software versions match on ALL screens, press the home button and proceed to Step 31.
30. If software versions DO NOT match, press the home button and return to Step 1.
31. Press the home button. - Press the CREW MODE button.
32. The software update is complete.
MUST
33. The menu file(s)
menu file.
1.25

Updating Menu Files

NOTE: This will overwrite any current product menu items and their settings. This may require re-entering any limited
time offering products cook times, temperatures, etc. and reassigning products to their locations on the touch screen
controller.
Switch all controllers to OFF.
1.
2. On the FAR-LEFT controller press the HOME button.
3. Press the SERVICE button.
4. Press the MANAGER button.
5. Enter 1656.
6. Press the check button.
7. Press the USB – MENU OPERATION button.
8. Press the COPY MENU FROM USB TO FRYER button.
9. The controller displays INSERT USB.
10. Open the far-left cabinet door and slide the USB cover up (see Figure 56).
11. Insert the USB flash drive (see Figure 57).
12. The controller displays IS USB INSERTED? YES NO
13. Press the YES button after the USB flash drive is inserted.
14. Controller displays READING FILE FROM USB. PLEASE DO NOT REMOVE USB WHILE READING.
15. Controller displays menu file(s) on the USB drive with .cbr suffix(es).
16. Press the desired menu file to load.
17. Controller displays SELECT VATS FOR MENU UPGRADE.
18. Press each vat to load the desired menu. If file is to load to ALL vats press each number (Example: In a 3-vat system, press 1,
2 and 3.
19. Press the check button.
20. Controller displays UI – UI DATA TRANSFER IN PROGRESS changing to MENU UPGRADE IN PROCESS.
21. Controller displays UPGRADE COMPLETE?
22. Press YES on each controller.
23. Controller displays MENU UPGRADE COMPLETED, REMOVE THE USB AND RESTART THE ENTIRE BATTERY.
24. Remove the USB flash drive and lower cover over the USB slot.
25. Cycle the fryer control power using the reset switch. This is located under the USB slot on the far-left side of the fryer (see
ENSURE THE SWITCH IS PRESSED AND HELD FOR 30 SECONDS.
Figure 58).
26. Push the filter pan back into the fryer until a "P" in NOT visible on the top right corner of the display.
27. Power on all controllers.
28. Wait for all vats to heat to setpoint and all product images are displayed.
29. Press the menu button to advance from ALL RECIPES to BREAKFAST to LUNCH to CHANGEOVER.
30. Ensure all products and images are in each menu.
31. Products may need reassigned to their locations and any limited time offer (LTO's) products may need to be reprogrammed
into each controller, as they may have been overwritten during the update.
be updated with this software update. Follow the steps in the next section(s) to update the
DO NOT POWER ON! Powering on the
1-51