Adjusting The Ignitor Assembly; Replacing The Filter Motor Or Filter Pump; Replacing The Frypot - Frymaster FilterQuick easyTouch FQG60T Service Manual

1.15.11 Adjusting the Ignitor Assembly

1. Disconnect the fryer from the electrical supply.
2. Remove the outer cover plate by removing two screws as shown
in Figure 30.
3. Remove the air shutter plate if applicable by removing the four
screws in the four corners as shown in Figure 31.
4. Gently bend the ignitor spark probe until the gap distance is
approximately ¼" inch
between the two points
as shown in Figure 32.
5. Reverse the steps to
reassemble.

1.15.12 Replacing the Filter Motor or Filter Pump

1. Disconnect the unit from the electrical power supply.
2. Remove the filter pan from the unit.
3. Position a container beneath the oil return fitting at the front of the cabinet. Disconnect the flexible oil line from
the fitting, allowing any residual oil to drain into the container.
4. At the rear of the fryer, unplug the left connector (as viewed from the rear of the fryer) from the transformer box.
5. Remove the four nuts and bolts attaching the motor mount to the rear motor mount support.
6. At the front of the fryer, remove the cover plate from the front of the motor and disconnect the motor wires.
7. Place a 1-foot (30.5-cm) length of wood (or similar support) beneath the motor mount near the front of the unit
and remove the two remaining nuts and bolts attaching the motor mount to the front cabinet cross brace.
8. Carefully remove the support and lower the motor mount to the floor, allowing the rear of the mount to slide
forward and off the rear motor mount support.
9. Disconnect the return flexline from the pump. The motor and pump assembly can now be pulled from beneath
the fryer and the failed component can be removed and replaced.
10. Position the replacement motor and pump assembly beneath the fryer and reconnect the oil return flexline to the
pump. Lift the rear of the motor mount up and onto the rear motor mount support.
11. Lift the front of the motor mount up and support it with a 1-foot (30.5-cm) piece of wood or a similar support.
Install but do not tighten the two nuts and bolts that attach the motor mount to the front cabinet cross-brace.
12. Install and tighten the four nuts and bolts that secure the motor mount to the rear motor mount support.
13. At the front of the fryer, tighten the two nuts and bolts at the front of the motor mount. Reconnect the motor
power wires and reinstall the wiring cover plate.
14. Reconnect the oil return flexline and reinstall the filter pan.
15. Reconnect the unit to the electrical power supply, fill the frypots with oil and check for proper operation.

1.15.13 Replacing the Frypot

1. If restraints are installed on the fryer, disconnect restraints prior to disconnecting the gas supply line.
2. Disconnect the fryer from the electrical and gas supplies.
3. Reposition the fryer to gain access to both the front and rear of the fryer.
4. Remove fryer door associated with the frypot replacement to simplify removal.
5. Remove the basket hanger. Units with basket lifts will require removal of the lift arms prior to removing the
basket hanger.
Figure 31
1-19
Figure 30
Figure 32