Loading And Updating Software Procedures - Frymaster OCF30 Service & Parts Manual

1.15

Loading and Updating Software Procedures

Updating the software takes approximately 30 minutes. The software only needs to be loaded in ONE controller or the
far left controller in a battery and it will update all the controllers and boards in the system. Press the TEMP button to
check current 3000 and ATO software version. Remove the bezel by removing the screws under the bottom of the
bezel. Remove the two screws securing the controller allow it to swing down. Remove the two screws on the left side
cover plate of the 3000 controller or far left controller in a battery.
To update the software, follow these steps carefully:
Left Display Right Display
OFF
UPGRADE IN
PROGRESS
CC
PERCENTAGE
UPDATING COMPLETE
BOOT
BLANK
CALL
UPGRADE IN
PROGRESS
IF_COOK
PERCENTAGE
HEXand COMPLETE
IF_aTO HEX
REMOVE SD
CARD
CYCLE
BLANK
POWER.
BOARD ID
Zero or a number
from 1-4
System OCF30
type
System
type
TYPE
TYPE
EXIT
OFF
OFF
OFF
OFF
OFF
With the controller folded down, insert the SD card, with the contacts facing
down and the notch on the bottom right (see Figure 7 and 8), into the slot on the
left side of the 3000 controller. ENSURE THE CARD IS FULLY
INSERTED INTO THE SD CARD SLOT.
WAIT
None required.
None required.
None required.
TECH
If this message is displayed, press the FILTER button and the software load will
continue.
WAIT
None required.
None required.
100
Remove the SD card using the fingernail slot on the top of the SD card.
Cycle the control power using the hidden reset switch under the far left control
box. ENSURE THE SWITCH IS HELD FOR 10 SECONDS.
Press the IO (Power) button.
Press the or  to choose correct fryer type. OCF30 (Frymaster)
Press . Ensure correct fryer type is displayed.
OCF30
Press the or  to select proper fryer model. One of several fryer models may
GL30
be displayed.
Once proper fryer model is displayed, press .
GL30

EXIT
Press the
OFF With the controller displaying OFF, VERIFY software update by pressing
the TEMP button to check updated 3000 version on each controller. 3000
should display software version 40.0159.03 for 3000 and 35.0157.00 for ATO.
OFF
Once the software has been updated and the versions are correct, replace the
cover and screws covering the SD card slot. Replace the screws attaching the
controller and replace the bezel and screws.
OFF
Using the instruction sheet 819-6806, perform tech mode setup and vat setup.
OFF
Set the current date and time using instructions 819-6806.
Action
(check) button.
1-39
Figure 7 Figure 8