Connection Of Switching Inputs And Outputs; Disassembling, Packing, Disposing; Figure 6.8: Connection Diagram Switching Inputs And Outputs Bcl 34 - Leuze electronic BCL 34 Series Technical Description

Installation
6.4.3

Connection of switching inputs and outputs

The BCL 34 is provided with a switching input and a switching output. The connection of the
switching inputs and outputs is carried out according to figure 6.8:

Figure 6.8: Connection diagram switching inputs and outputs BCL 34

Switching input
In the standard setting, you can trigger a reading action via the switching input connection
SWIN by connecting SWIN (pin 4) and VOUT (pin 1). Likewise, the BCL 34 can be activated
via a Leuze sensor that is connected to the MS 34 105 through a standard sensor cable.
Switching output
The switching output connection between SWOUT (pin 2) and GND (pin 3) is normally open.
In the standard setting, SWOUT is closed in case of a reading error.
Notice!
You can configure the switching inputs and outputs according to your requirements by using
the modules 13
6.5

Disassembling, Packing, Disposing

Repacking
For later reuse, the device is to be packed so that it is protected against shocks and damp-
ness. Optimal protection is achieved when using the original packaging.
Notice!
Electrical scrap is a special waste product! Observe the locally applicable regulations re-
garding disposal of the product.
36
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
A
Sensor
max.
100 mA
(Switching input) and 14
BCL 34
Connector SW IN/OUT
4 SWIN
1 V OUT
2 SW OUT
3 GND
5 PE
1 V IN
3 GND IN
Connector PWR
(Switching output).
Leuze electronic
Leuze electronic